Z Lcd Brightness; Z Lcd Contrast; Z Alarm Volume; Z Standby Function - Schulthess 7220.1 Bedienungsanleitung

LCD Brightness (ex factory 150)
Select «Extended basic settings»!
The button can be used to alter the brightness or
text on the display.
LCD Contrast (ex factory 26)
Select «Extended basic settings»!
The button can be used to alter the contrast on the
display.
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The level can be adjusted in 3 levels.
Off
Level 1
Level 2
Level 3
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. All displays are dark.
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory DEUTSCH)
Select «Extended basic settings»!
If another language is temporarily selected via the
buttons a nd
in standby mode or after a long standstill, the setting
reverts back to the default language.
Start time preselection (ex factory 24 HOURS)
Select «Extended basic settings»!
The maximum adjustable range of the start time delay
can be reset from 24 hours to 100 hours.
, 4 minutes after programme end,
59
Problems

Error messages

If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectified.
«CHILD LoCK ACTIVE»
X Hold the start button down and press the fast for-
ward button (see chapter «Basic settings»).
«PLEASE CLoSE Door»
X Push door closed until lock engages.
«CoND. WATEr FULL»
X Condensate water pump is not running.
Check if the water discharge hose is bent or the water
discharge provided by the customer is clogged.
If the machine displays an F - - error message:
X Interrupt the programme using the fast forward
button and select a new programme.
If error messages appear repeatedly:
X Switch off the power for around 1 minute and switch
it back on again. (Pull out the plug or switch off at the
wall).
 The machine is ready for use again when the pro-
gramme control lights flash.
X Select a new programme.
If an error message appears again:
X Make a note of the error message.
X Unplug the machine or switch it off at the wall.
X Notify customer services.

Troubleshooting

Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.
rectifying minor faults yourself
The machine does not start after pressing a
programme button:
X Check whether the mains power is switched on at the
wall and the plug is in.
X Check whether all the fuses are intact or the safety
switch has tripped.
The display is dark:
X The machine is in standby mode. No error. To operate
the machine press any button.
The machine does not start:
X The start button has not been pressed.
X Start time preselect has been set. Only starts at the
preselected start time.