Crease Protection; Setting The Time; Language; Extended Basic Settings - Schulthess SPIRIT TC 5306 Bedienungsanleitung

Crease protection (ex factory 3OMIN)
+
When this function is switched on, the crease protection
phase begins at the end of the programme.
Setting the time (the time is not set ex factory)
+
The hours can be set using the
minutes using the
Language (ex factory GERMAN)
+ ÷
The basic language is changed and is retained even after
switching the machine off or putting it in sleep mode.

Extended basic settings

+ +
By pressing these three buttons at the same time, the
display shows the extended basic settings.
Repeatedly pressing the
possible settings.
Pressing the
changed.
Pressing the
settings.
Child lock (ex factory OFF)
Select «Extended basic settings»!
The child lock is to prevent accidental starting, changing or
deletion of a programme by small children.
Operating the machine with the child lock switched on:
+
Hold the start button down and press the fast forward
button.
Low voltage (ex factory OFF)
Select «Extended basic settings»!
If the mains voltage is reduced, the programme times will
be extended accordingly.
Off = 400 V 2N ~ 3,25 kW / 10 AT
Off = 230 V 1N ~ 3,25 kW / 16 AT
On = 230 V 1N ~ 2,05 kW / 10 AT
LCD Brightness setting (ex factory 150)
Select «Extended basic settings»!
The button can be used to alter the brightness or
text on the display.
button and the
button.
button shows the
button allows the settings to be
button interrupts the display of the
48
LCD Contrast setting (ex factory 32)
Select «Extended basic settings»!
The button can be used to alter the contrast on
the display.
Summer noise level (ex factory NOISE LEVEL 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The volume can be adjusted in 3 levels.
Off
Volume 1
Volume 2
Volume 3
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. All displays are dark.
Optical interface (ec factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer ser-
vices can communicate with the machine by PC.
Problems
Repairs, alterations or intervention on electronic equipment
should only be carried out by qualified specialists. Inexpert
repairs can cause considerable damage and risk to the user.
Only original spare parts should be used for repairs.

Rectifying minor faults yourself

The machine does not start after pressing a
programme button:
Check whether the mains power is switched on at the
wall and the plug is in.
Check whether all the fuses are intact or the safety
switch has tripped.
The machine does not start:
The start button has not been pressed.
Start time preselect has been set. Only starts at the
preselected start time.
The drying target is not achieved or the drying
time is too long:
Clean the moisture sensors on the vanes in the drum
(see page 46).
Power cut (check EW power cut times).
The laundry is not dry after the maximum
possible settings:
Drum is overloaded.
Laundry not sufficiently spun.
Insufficient room ventilation (open a window or door).
The filter in the door is blocked with fluff (clean filter).