Airless Gun 009 St - Storch Airless ST 900 Bedienungsanleitung

Airless gun 009 ST

Technical Data
Permissible material operating pressure 248 bar
Size of nozzle opening
Weight
Inlet opening
Maximum material temperature
Wetted parts
Noise level*
- Sound power
- Sound pressure
*Measured at 1 m distance during spraying material with water at relative thickness of 1.36
through a nozzle 517 at 207 bar corresponding with ISO 3744.
RISK OF FIRE AND EXPLOSION
Flammable fumes in the work area, such as solvent and paint fumes, in the work area may ignite or explode.
Paint or solvent flowing through the device may cause static spark formation. This thus reduces the risk of fire
and explosion:
• Only use device in well-ventilated areas.
• Eliminate possible sources of ignition, such as pilot lights, cigarettes, flashlights and plastic protective shee-
ting (risk of static spark formation).
• Earth all devices in the work area. See earthing instructions.
• Never spray or rinse solvent under high pressure.
• Keep the work area free from clutter, including solvents, cloths and petrol.
• Do not insert or unplug any power cables and do not actuate any light or power switches when flammable
vapours are present.
• Use only earthed hoses.
• Hold the gun firmly to the side of the earthed pail when spraying into it. Only use antistatic or conductive
bucket inserts.
• Stop operation immediately as soon as static spark formation occurs or an electric shock is felt. Only use the
device again once the problem has been identified and corrected.
• An operational fire extinguisher must be present in the work area at all times.
Setup
Pressure relief
Observe the pressure relief procedure if you see
this symbol.
Trigger
It is easy to convert the pistol from a 4-finger trigger to
a 2-finger trigger. Select the trigger for your preferred
handling. How to replace the trigger:
1. Unlock the protective clip for the pistol trigger.
2. Swivel the protective clip to the side.
3. Unscrew the retaining nut from the pistol trigger axle
bolt, bolt from the pistol housing.
4. Remove trigger.
5. Fit the other trigger in the reverse order.
Connect the pistol to the sprayer
Make sure the spray gun is switched off and disconnected
Original instruction
3.18 mm
163 g
1/4 npsm swivel
49° C
stainless steel, polyurethane, nylon, aluminium,
tungsten carbide, solvent-resistant elastomers,
brass
87 dBa
78 dBa
184
from the socket. Refer to the sprayer's operating instruc-
tions for information regarding venting and spraying.
1. Attach the Airless hose to the spray gun's material out-
let.
2. Attach the other end of the Airless hose to the pistol
swivel joint. Securely tighten all connections with two
spanners (one on the swivel joint and one on the hose).
Affixing the nozzle and tip guard
In order to avoid leakages on the spray tips, make sure
that the spray tip and tip guard are correctly installed.
1. Follow pressure relief procedure.
2. Lock gun safety latch.
3. Make sure that the spray tips and the tip guard are
assembled in the order pictured.