Safety Precautions - Daikin FWC07AATNMV1 Installationsaleitung

Indoor Unit: FWC07AATNMV1 / FWC08AATNMV1 / FWC10AATNMV1 / FWC11AATNMV1 /
FWC12AATNMV1
820
! WARNING
• Installation and maintenance should be performed by
qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the
national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to
that of the name plate before commencing wiring work
according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazard
due to insulation failure.
• All electrical wiring must not touch the water piping or
any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before
installing or servicing the unit.
• Risk of electric shock, can cause injury or death.
Disconnect all remain electric power supplies before
servicing.
• DO NOT pull out the power cord when the power is ON.
This may cause serious electrical shocks which may result
in the fire hazards.
• Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1m from TVs and radios, to
prevent distorted pictures and static. {Depending on the
type and source of the electrical waves, static may be heard
even when more than 1m away}.
Disposal requirements
Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not
be mixed with unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refrigerant,
of oil and of other parts must be done by a qualified installer in accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring
this product is disposed of correctly, you will help to prevent potential negative consequences for the environment
and human health. Please contact the installer or local authority for more information.
Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local
and national legislation.
OUTLINE AND DIMENSIONS
363
335
113
SEE DETAIL A
158
DETAIL A
WATER OUTLET
WATER INLET

SAFETY PRECAUTIONS

Please take note of the following important points when
installing.
• Ensure that the drainage piping is connected properly.
• Ensure that the unit's panel is closed after service or
• Air swing connector and LED wire connector shall be
• Sharp edges and coil surfaces are potential locations which
• Before turning off the power supply set the remote
• Do not operate any heating apparatus too close to the air
• Ensure the color of wires of the outdoor unit and the
• IMPORTANT : DO NOT INSTALL OR USE THE AIR
NOTICE
1
930
28
642
555
! CAUTION
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.
installation.
Unsecured panels will cause the unit to operate noisily.
inside the control box.
may cause injury hazards. Avoid from being in contact
with these places.
controller's ON/OFF switch to the "OFF" position to
prevent the nuisance tripping of the unit. If this is not done,
the unit's fans will start turning automatically when power
resumes, posing a hazard to service personnel or the user.
conditioner unit. This may cause the plastic panel to melt or
deform as a result of the excessive heat.
terminal markings are same to the indoors respectively.
CONDITIONER UNIT IN A LAUNDRY ROOM.
All dimensions are in mm.