Transportation; Handling The High-Pressure Hose; Interruption Of Work - WAGNER Super Finish 23i Originalbetriebsanleitung

GB
5

TRANSPORTATION

Unroll high-pressure hose and lay it over the shaft.
Loosen terminal sleeves (item 1) on the shaft ( open). Extract
shaft to the desired length. Tighten terminal sleeves again by
hand ( closed)..
Transportation in vehicle
Secure the unit in the vehicle by means of suitable fasteners.
The device can be placed on its side if necessary. In this case,
please ensure that no attachments can be damaged. Atten-
tion: Paint or solvent residues can escape from the connec-
tions!
38
6
The unit is equipped with a high-pressure hose specially suit-
ed for diaphragm pumps.
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
1
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Wagner spray gun with a swivel joint
and a hose system.
7
1. Open the discharge tap, then set the ON/OFF switch OFF.
2. Pull the trigger on the gun or open the material ball cock
For spray work
3. Secure the gun, refer to the operating manual of the gun.
4. Remove tip from tip holder and store the tip in a small ves-
HANDLING THE HIGH-PRESSURE
HOSE
Danger of injury through leaking high-
pressure hose. Replace any damaged high-
pressure hose immediately.
Never repair defective high-pressure hoses
yourself!
When using the high-pressure hose while
working on scaffolding, it is best to always
guide the hose along the outside of the scaf-
folding.
The risk of damage rises with the age of the
high-pressure hose.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
Only use WAGNER original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.

INTERRUPTION OF WORK

If using quick-drying or two-component
coating materials, do not fail to rinse unit
through with a suitable cleaning agent dur-
ing the processing period. Follow for the rel-
evant instructions in chapter 8.
to depressurize the high-pressure hose.
sel with suitable cleaning agent.
Super Finish 23i