Installation; Parent Unit & Baby Unit; Placement Tips - Alecto DBX-68 Gebrauchsanleitung

2 INSTALLATION

2.1 PARENT UNIT & BABY UNIT:
Both the parent unit and baby unit are powered through the supplied
battery pack. You may charge this pack using the supplied power adaptor in
combination with the charger.
1. Slide the battery cover off the parent unit or
baby unit.
2. Insert the supplied battery pack into the
parent-unit and connect the plug with the
parent-unit. Pay attention, the plug only fits
one way. Never force its connection.
ATTENTION: ONLY INSTALL THE SUPPLIED BATTERY PACK!
INSTALLING DIFFERENT MODELS CAN CAUSE DAMAGE OR
3. Replace the battery cover and place each unit
onto the supplied chargers. The chargers are
identical, which means you can use any one of
them.
4. Connect the power adaptor with the wider plug
to the DC5V input at the rear of the charger
and plug the power adaptor into a 230 Volts
wall socket.
Only connect the supplied adaptor. Connecting any other power
adaptor can cause damage to the baby intercom or even fire.
5. The battery indicator on the charger and the CHARGE indicator on and
the battery pack will start charging.
EVEN EXPLOSION

2.2 PLACEMENT TIPS:

water-proof; you must protect it against moisture at all times.
39
• Do NOT place the baby-unit in bed with
the baby, maintain a distance of 1 to
2 meters between the baby and the
baby-unit.
• MAKE SURE THE BABY CANNOT
TOUCH THE ADAPTOR CABLE.
• Do not expose the baby-unit or
parent-unit to direct sunlight or
humid areas. This baby intercom is
not water-proof, penetrating moisture
can cause damage to the electronics.
• The Baby Monitor is suitable for use
up to -15°C. The DBX-68 is NOT