Wiring Connection - Kenwood KDC-X5200BT Bedienungsanleitung

INSTALLATION/CONNECTION

Wiring connection

Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
A4 Yellow : Battery
Blue/White * 1
A5 : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
Purple ]
B1
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
B2 Purple/black [
B3 Gray ]
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
B4
White ]
B5
: Front speaker (left)
For 3-way crossover: Mid range speaker (left)
White/black [
B6
B7 Green ]
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
B8 Green/black [
28
ENGLISH
Antenna terminal
Ignition wire (Red)
Unit
Battery wire (Yellow)
Fuse (10 A)
If no connections are made, do not let the wire come out from
Yellow (Battery wire)
Light blue/yellow
Red (Ignition wire)
(Steering remote
control wire)
Red (A7)
Blue/White *
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
ISO connectors
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially available
custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
the tab.
STEERING WHEEL
REMOTE INPUT To the steering wheel remote control
adapter
REMOTE CONT
To the power control terminal when
2
ANT CONT
using the optional power amplifier
or to the antenna control terminal
P. CONT
in the vehicle
To connect the Kenwood navigation
system, refer your navigation manual
MUTE
NOTE: Total output for Blue/White wire ( *
12 V 350 mA.
1 ) + ( * 2
) is