Gryzzly HDR 100 Originalbetriebsanleitung Seite 17

that has been converted without the
approval of the manufacturer. Before
initial operation, have a specialist
check that the required electrical pro-
tection measures are in place.
• Do not operate the equipment if the
mains cable, water supply or other
important parts such as the high-
pressure hose or gun are damaged/
leaking.
• Protect the pressure cleaner from
frost and dry running.
• High-pressure hoses, fittings and
couplings are important for machine
safety. Use only high-pressure hoses,
fittings and couplings recommended
by the manufacturer.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an authorised electrician.
In the case of repairs, always contact
our service centre.
Electrical safety:
Caution: to avoid accidents and
injuries from electric shocks:
• The plug and socket of an extension
cable must be water-tight!
Unsuitable extension cables can
be dangerous as people can be
harmed by an electric shock!
• Protect the electric plug connections
against moisture.
• If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage match-
es the specifications on the rating
plate.
• Connection to the mains must be
carried out by an experienced electri-
cian and meet the requirements of
IEC 60364-1.
• The electrical installation shall be ac-
cording to national wiring rules.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated
leakage current of not more than 30
mA. Fuse: at least 13 ampere.
• Before each use, check the equip-
ment, cable and plug for damage.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Do not pull the plug from the socket
by the cable. Protect the cable from
heat, oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are
protected from spray water and de-
signed for outdoor use. Always fully
unroll a cable drum before use. Check
the cable for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of the power sup-
ply cable must not be less than
2 x 2,5 mm².
• Wear sturdy footwear to protect
against electric shock.
GB
17