Transport; Storage - ATIKA HT 315 Originalbetriebsanleitung

⇒ Take out table insert 32:
• Insert the holding mandrel (A) in part 32.
• Pull the part in the direction of the arrow.
• Take out table insert.
⇒ Removing the saw blade:
• Insert rod A into motor-shaft and unscrew bolt
( left-hand-thread)
• Remove part 30
• Now remove saw blade
• Assembly of a new saw blade to be done in reverse sequence
• Ensure correct position of splitting wedge (Fig. 11)
Blade guard adjustments
The setting of the splitting wedge must be checked after each
saw blade change.

Transport

Before each transport:
switch off device
−
wait for standstill of the saw blade
−
pull out mains plug
−
accessories such as stops must be securely
−
mounted or clamped on the machine.
2 persons are required to transport the saw.
Wear protective gloves to prevent injury.
We recommend our carriage, order no. 301892, for the
convenient transport of the saw.

Storage

Pull out mains plug.
Store unused equipment in a dry, locked place out of the
reach of children.
Before a longer period of storage carry out the following to
extend the machine's service life and ensure an easy
operating:
− thoroughly clean the device.
− treat all movable parts with an environmentally friendly oil.
Never use any grease!
17