Dometic CAM35 Montage- Und Bedienungsanleitung Seite 11

CAM35
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
• The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following installation instructions:
• Secure the parts of the camera which are installed in the vehicle in such a way that
they cannot become loose under any circumstances (sudden braking, accidents)
and cause injuries to the occupants of the vehicle.
• Secure any parts of the system concealed by the bodywork in such a manner that
they cannot be come loose or damage other parts or cables, or impair vehicle
functions (steering, pedals, etc).
• To prevent damage when drilling, make sure there is sufficient space on the other
side for the drill head to emerge.
• Deburr all drill holes and treat them with a rust-protection agent.
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be per-
formed by qualified specialists.
Observe the following instructions when working with electrical parts:
• When testing the voltage in electrical cables, only use a diode test lamp or a volt-
meter.
Test lamps with a bulb consume too much voltage, which can damage the vehi-
cle's electronic system.
• When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 1, page 3).
• Insulate all connections.
• Secure the cables against mechanical wear by using cable binders or insulating
tape, for example on existing cables.
EN
Safety and installation instructions
11