Self-Diagnosis Program - Waeco MagicSpeed MS880 Montage- Und Bedienungsanleitung

MagicSpeed MS880
Drive the vehicle at any speed above the activation speed (40 km/h) to set
the GAIN value.
Press the SET button.
The cruise control switches itself on.
Press the SET button again to increase the GAIN value or
... press the RES button to decrease the GAIN value.
You will hear a signal each time you press the button.
To save the set values, apply the brake.
Quit setup mode (chapter "Quitting setup mode" on page 99).
12.8 Quitting setup mode
To quit setup mode, proceed as follows:
Stop the vehicle.
Apply the brake and hold it down.
Press the SET button four times.
You will hear a long signal.
You have now quit setup mode.
13

Self-diagnosis program

MagicSpeed MS880 has a self-diagnosis program. After activation in driving
mode, the cruise control or the speed limiter (variable) deactivates itself au-
tomatically if there is a fault. In this case, the cause of the fault is indicated by
a series of high-pitched beeps.
The cruise control or speed limiter switches off:
if one of the control element buttons is jammed or held down for longer
than 20 s. There is one high-pitched beep.
if the current speed increases unusually (> 9 km/h per second). There are
two high-pitched beeps.
if the current speed is less than 33 km/h. There are three high-pitched
beeps.
EN
Self-diagnosis program
99