Front Panel - Omnitronic MX-410 Bedienungsanleitung

Front panel

1. REAR MIC IN-LED
If the rear socket is in use, the REAR MIC IN-LED on the front panel lights up.
2. DJ MIC-SOCKET
Connect your microphone with ¼" jack or XLR-plug here. For permanent installations, we recommend to use
the socket on the rear panel.
3. MIC TREBLE-CONTROL
Used to increase or lower the HIs of the MIC input signal.
4. MIC MIDDLE-CONTROL
Used to increase or lower the MIDs of the MIC input signal.
5. MIC BASS-CONTROL
Used to increase or lower the LOWs of the MIC input signal.
6. MIC LEVEL-CONTROL
With the MIC Level-control, you can adjust the microphone volume.
7. ON AIR-BUTTON
Used to switch the microphone on or off.
8. TALKOVER-BUTTON
Press this button if you want to use your microphone. When the button is pressed, all signals but the
microphone level are attenuated by 15 dB.
9. CHANNEL-FADER
Used to adjust the input level of each channel.
10. X-FADER ASSIGN-SELECTOR
With the Assign selectors, you can route the signal through the crossfader rather than directly to the mix.
You have three options:
A The channel signal is routed to the crossfaders' left side (position A)
M The channel signal is not routed to the crossfader.
B The channel signal is routed to the crossfaders' right side (position B)
23/28 10006750_V_1_1.DOC