Rack Mounting - Omnitronic MX-410 Bedienungsanleitung

• Connect the connection cable of the power-unit with the AC IN-socket. Plug the power unit into your outlet.
• With the POWER-switch, you can switch the device on and off.
Occupation balanced XLR-connection:
Occupation jack plug:

Rack mounting

The MX-410 is built for 19" racks/483mm. The minimum mounting depth is housing depth plus 100 mm for
plugs and cables. The height is 220 mm. You can fix the device with four screws M6 in the rack.
When mounting the device into a rack, please make sure that there is a proper air circulation.
Please make sure that there is enough space around the device so that the heated air can be passed on.
The rack should be provided with a cooling fan.
Balanced use with XLR connectors
1
2
1 = Ground / Shield
2 = Hot (+)
3 = Cold (-)
3
Input
For unbalanced use pin 1 and pin 3 have to be bridged
Unbalanced use of
mono 1/4" jack plugs
Tip =
Signal (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp
1
Balanced use of
stereo 1/4" jack plugs
Tip =
hot (+)
Ring =
cold (-)
Sleeve =
Ground / Shield
Tip
Ring
Sleeve
Strain relief clamp
For connection of balanced and
unbalanced plugs, ring and sleeve have
to be bridged at the stereo plug.
21/28
2
3
Output
10006750_V_1_1.DOC