Troubleshooting - Bosch B25L Gebrauchsanleitung

en
Do not use descaling agents for rinsing out the boiler, as
they could damage it.
1. Check that the appliance is cold and unplugged for
more than 2 hours, and that the removable water tank
(1) is empty.
2. Place your appliance on the edge of your kitchen
sink.
3. Remove the plastic cover located on the bottom of the
appliance by turning it to the
4. Unscrew the boiler drainage plug located on the
bottom of the appliance using a coin.
5. Holding your steam generator in upside down position,
and using a jug, fill the boiler (in the base unit) with 1/4
litre of water
6. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To obtain
the best result, we recommend that this operation is
done twice
Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug with a
coin.
8. Insert and close the plastic cover by turning it to the
position.
Automatic clean warning
(depending on model)
Pilot light (8) will flash indicating that boiler must be
rinsed. To do this, follow the procedure described in the
section above.
To reset "Calc'n clean" pilot light and counter, switch the
station off twice, keeping it off during at least 30 seconds
each time
Trouble shooting
Problem
The steam generator
• There is a connection problem.
does not come on.
• The main power button is not switched on.
The iron does not
• The main power button is not switched on.
heat up.
• The temperature control knob is set to the
"min" position.
14
Rinsing the iron steam chamber (G)
This procedure helps to remove scale particles out of the
steam chamber.
Carry it out approximately every 2 weeks, if the water in
your area is very hard.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (13) of the iron to the
position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power switch
e) Wait until the "steam ready" indicator lamp (7) lights
f) If the steam station has steam regulator (3), set it to
g) Hold the iron over the sink or a container to collect the
h) Press the steam release button (15) and gently shake
i) Set the temperature selector (13) of the iron to the
j) To clean the soleplate, immediately rub off any residue
Possible causes
"min" position.
(6) to the "I" position.
up.
the maximum position ("10").
water.
the iron. Boiling water and steam will come out,
carrying scale and or deposits that might be there.
This could take approximately 5 minutes.
"max" position, without pressing the steam release
button (15). The water in the steam chamber will start
evaporating. Wait until all the water inside the chamber
has been evaporated.
by running the hot iron over dry cotton cloth.
Solution
• Check the mains cable, the plug and the
socket.
• Set the main power button (6) to the "I"
position.
• Set the main power button (6) to the "I"
position.
• Set the temperature control knob (13) to the
desired position.