Commissioning; Initial Start-Up; Appliance Handover - STIEBEL ELTRON DHM 3 Installation

INSTALLATION

Commissioning

Material losses
!
Take note of the type plate. The specified voltage must
match the mains voltage.
f Connect the power cable as shown in the wiring diagram f
(see chapter "Specification / Wiring diagram").
26 | DHM
5. Commissioning
5.1

Initial start-up

f Fill the appliance by running the tap several times until the f
pipework and appliance are free of air.
f Carry out a tightness check. f
f Insert the power cable plug, if present, into the standard f
safety socket or set the fuse/MCB.
f Check the function of the appliance. f
5.2

Appliance handover

f Explain the appliance function to users and familiarise them f
with its operation.
f Make users aware of potential dangers, especially the risk of f
scalding.
f Hand over these instructions. f
www.stiebel-eltron.com