Working With The Power Tool - Flex SE 14-2 150 Originalbetriebsanleitung

Preselecting the speed
To set the operating speed, move the dial
to the required value.
The speed can be set from 600–2,100 min
Setting
1
2
3
4
5
6

Working with the power tool

t^okfkd>
qÜÉ=êçí~íáåÖ=ë~åÇáåÖ=ÇáëÅ=ãìëí=åçí=ÅçãÉ=
áåíç Åçåí~Åí=ïáíÜ=ëÜ~êé=éêçàÉÅíáåÖ=çÄàÉÅíëK=
a~åÖÉê=çÑ=âáÅâÄ~Åâ>=a~ã~ÖÉ=íç=ë~åÇáåÖ=
é~ÇK=fÑ=íÜÉ=ë~åÇáåÖ=é~Ç=áë=Ç~ã~ÖÉÇ=
çê ëÉîÉêÉäó=ïçêåI=áí=ãìëí=ÄÉ=êÉéä~ÅÉÇK
`^rqflk>
eçäÇ=íÜÉ=ÉäÉÅíêáÅ=éçïÉê=íççä=ïáíÜ=ÄçíÜ=Ü~åÇë>=
1. Attach sanding tool.
2. Check position of the guard.
3. Connect dust extraction system.
4. Insert mains plug.
24
–1
–1
Speed (min )
600
900
1,200
1,500
1,800
2,100
5. Switch on dust extraction system.
6. Switch on the power tool.
7. Place electric power tool on the work
surface. The brush ring must be flush
with the work surface.
8. Increase the pressure to bring the sanding
pad into contact with the work surface.
In doing so, slew the electric power tool
with overlapping movements.
9. Sanding in corners:
– Switch off the power tool and wait until
the sanding tool has come to a standstill.
– Pull out pivoted edge segment and swivel
.
to left.
– Switch on power tool again.
– Place electric power tool on the work
surface.
10. After work, switch off the electric power
tool and pull out the mains plug.
SE 14-2 125/SE 14-2 150