Ssi Mono-Time; Failure-Handling; Function External Output; Level Fail Output - TR-Electronic LE-25 Benutzerhandbuch

5.2.5 SSI Mono-Time

Lower limit
Upper limit
Default

5.3 Failure-Handling

5.3.1 Function external output

Determines the function of the error output (external switching output). Definition of
errors see "Device state", page 51.
Selection
disabled
Temperature
Intensity
Hardware-Fail
every fail
Speed-check
Plausibility measured value

5.3.2 Level Fail Output

Specifies the active output level of the selected error, if the error occurs.
Selection
active HIGH
active LOW

5.3.3 Failure-quit

Determines, whether occurring error reports should be cleared automatically after
eliminating the trouble.
Selection
automatic
not automatic
Printed in the Federal Republic of Germany
06/08/2017
20 μs
250 μs
20 μs
Description
Error active, Switching Output = HIGH
Error active, Switching Output = LOW
Description
An occurring error report is cleared automatically
after remedying of the error.
An occurring error report can be cleared only via
the external switching input (see "External Input",
page 49).
TR - ELE - BA - DGB - 0026 - 00
Default
X
Default
X
Default
X
 TR-Electronic GmbH 2017, All Rights Reserved
Page 47 of 55