Key Beep; Time Out Timer (Tot) Setting (Advanced Mode Only); Call Alert; Clone Function (Advanced Mode Only) - Albrecht Tectalk Pro XL Bedienungsanleitung

Key Beep

If the Key Beep is activated, your radio will emit a confirmation tone
whenever you use the keypad. You can activate or deactivate the Key Beep
as required.
To change the Key Beep setting, press the MODE button until the Key Beep
icon appears. Use the UP or DOWN button to change the setting. Press the
PTT or FUNCTION button or wait for 5 seconds to store your choice.
The Key Beep icon will appear when Key Beep is active.

Time Out Timer (TOT) Setting (advanced Mode only)

This timer is used to limit the transmit time of your radio. By selecting a timer
setting, your radio will automatically release the PTT when the selected time
limit is reached.
To change or select the TOT time, press the MODE button until the TOT
icon appears. Use the UP or DOWN button to change the setting. Press the
PTT or FUNCTION button or wait for 5 seconds to store your choice.
The TOT icon will appear when Key Beep is active.

Call Alert

To alert other users to your message and gain their attention you can send a
Call Alert melody by pressing the PTT button twice in quick succession.
There are five different call alert tones and a tone off position.
To change the Call Alert melody, press the FUNCTION button until 'CA'
appears. Use the UP or DOWN button to change the setting. Press the PTT
or FUNCTION button or wait for 5 seconds to store your choice.

Clone Function (Advanced Mode only)

The settings of your radio (except the Radio ID) can be transferred to or from
another Tectalk Pro XL. To perform this function you will need a TCC-1000
Cloning cable (available separately).
•
Place the two radios side by side and connect the Cloning Cable.
•
Switch on the unit whose settings are to be copied (the
master unit). Press the MODE button until ‚CL' appears.
Use the UP or DOWN button and select ‚OUT'. Press the
16