Dual Watch Mode; Roger Beep - Albrecht Tectalk Pro XL Bedienungsanleitung

To select the Priority Channel Scan Time, press the MODE button until the
Priority Channel Scan Time icon and current setting flashes. Use the UP
or DOWN button to change the priority channel scan time. Set the scan time
to '1' for most frequent and '5' for least frequent. Press the PTT or MODE
button or wait for 5 seconds to store your choice.
Each number represents a half second, so a setting of '4' will result in the
priority channel being checked every 2 seconds. A setting of '1' will cause
the radio to scan the priority channel alternately with the other channels, e.g.
channel 1, priority channel, channel 2, priority channel etc.

Dual Watch Mode

Dual Watch mode allows you to monitor two channels; a primary channel
and the dual watch channel. When a signal is received on either channel the
unit will pause for 5 seconds before resuming the dual watch.
To activate the dual watch mode, first select a radio channel (see
Channels) as the primary channel. To select the dual watch channel press
the MODE button until the Dual Watch Icon and current setting will flash.
Use the UP or DOWN button to select the desired dual watch channel. Press
the PTT or MODE button or wait for 5 seconds to store your choice and
activate the dual watch.
The radio display will alternate between the primary and dual watch
channels and the dual watch icon will appear.
To deactivate the dual watch press the SCAN button. If you press the PTT
button whilst receiving a signal in Dual Watch Mode the radio will transmit on
the currently displayed channel. If you press the PTT button when no signal
is present the radio will transmit on the primary channel.

Roger Beep

The Roger Beep is a short tone that is automatically added to the end of
your transmissions to tell other users that you have finished speaking. You
can activate or deactivate the Roger Beep as required.
To change the Roger Beep setting, press the MODE button until the Roger
Beep icon and current setting will flash. Use UP or DOWN to change the
setting. Press the PTT or FUNCTION button or wait for 5 seconds to store
your choice.
The Roger Beep icon will appear when Roger Beep is active.
15