Kärcher KM 100/100 R Bp Pack Handbuch Seite 26

Unscrew retaining nuts for rear sealing
strip.
Screw on new sealing strip.
Side sealing strips
Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
Screw on new sealing strip without fully
tightening the nuts.
To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
Adjust sealing strip.
Tighten nuts.
Screw on side panels.
Push in the waste containers on both
the sides and lock them.
Replacing dust filter
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
Turn main key to "0" and remove it.
Press emergency-stop button.
Open the hood, insert retaining rod.
Pull out the filter holder to the maximum
possible extent and lock.
Remove the lamella filter.
Insert new filter.
26
Make sure driver engages with holes on
drive side.
Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing filter case seal
Lift filter case seal out of groove in the
cover.
Insert new seal.
Checking drive belt
Turn main key to "0" and remove it.
Press emergency-stop button.
Open the hood, insert retaining rod.
Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
Check tension, wear and damages on
the V-belt of the sweep roller drive.
10
-
EN
Check cup seal
Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing fuses
Loosen screws on both sides of the
panel.
Replace defective fuses.
Replace front panel.
Note: Only use fuses with identical safety
ratings.
Pole fuse
1 Nut
2 Battery charging cable
3 Pole fuse
4 Jumper
5 Screw
Replace defective fuse.
Note:A defective pole fuse may only be re-
placed by a Kärcher service technician or
an authorised expert.