Meaning Of The Leds - ZyXEL Communications VMG8029 Schnellstartanleitung

Meaning of the LEDs

B
PWR
green on Power supply present.
green flashing slowly
Waiting for link detection (pos-
sibly no cable plugged in)
green flashing quickly
Authentication running
red briefly on The device is being started or
reset to the factory settings
red on >10sec An error has occurred.
red flashing New firmware is being loaded.
off Power supply not present.
C
SIP
green on SIP account is successfully
registered.
flashing slowly
SIP account is being registered.
flashing quickly Active ongoing call.
flashing red At least one SIP account regis-
tration has failed.
off Internet telephony not enabled
D
BCK
Currently without function
E
WEB
green on Internet connection established.
green flashing Data transmission over ac-
tive Internet connection
red on Internet connection setup failed
(e.g., due to incorrect access
credentials)
off No Internet connection.
F
WAN1 (VDSL/ADSL)
green and yellow on
VDSL connection is active.
only green on ADSL connection is active
green flashing quickly DSL synchronization
is in progress.
green flashing slowly
DSL synch failed or DSL cable
not plugged in
off DSL interface not activated,
WANoE connection detected or
configured
G
WAN2 (ETH)
green on 100 Mbps connection to the
modem
green and yellow on 1Gbit/s connection to
the modem.
flashing Data traffic on the interface.
off No network device connected.
H
LAN1/LAN2
green on 100 Mbps connection active.
green and yellow on
1 Gbit/s connection active.
flashing Data traffic on the interface.
off No network device connected.
I
S 1-4
0
left green on User channel B1 is busy.
left green off User channel B1 is not used.
right green on User channel B2 is busy.
right green off User channel B2 is not used.
Rear panel
Master
green on Gateway is in master mode.
Slave
yellow on Gateway is in slave mode.
EN
©2017 | 17