Wiring Plan, Single Chamber Housing - SICK LBV 330 Betriebsanleitung

LBV 330 • - Relay (DPDT)
Remove approx. 10 cm (4 in) of the cable mantle, strip approx.
3
1 cm (0.4 in) of insulation from the ends of the individual wires
Insert the cable through the cable gland into the sensor
4
Lift the opening levers of the terminals with a screwdriver (see
5
following illustration)
Fig. 8: Connection steps 5 and 6
Insert the wire ends into the open terminals according to the wiring
6
plan
Press down the opening levers of the terminals, you will hear the
7
terminal spring closing
Check the hold of the wires in the terminals by lightly pulling on
8
them
Tighten the compression nut of the cable entry. The seal ring must
9
completely encircle the cable
10 If necessary, carry out a fresh adjustment
11 Screw the housing cover on
The electrical connection is finished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the EEx-d
version.
5 Connecting to power supply
17