Assembling The Radias-R And Rd-Kb - Korg RD-KB Bedienungsanleitung

Assembling the RADIAS-R and
RD-KB
Caution notes:
In order to assemble the system correctly and safely,
please observe the following points.
Perform each step in the order described, and be
sure that you have the correct part in the correct
orientation at each step.
Avoid moving the system before you've finished
assembling it, or the RADIAS-R module may fall
back down, causing injury or damage.
The support arm may be bent or other damage
may occur if you apply excessive force before
you've finished tightening the screws.
Attaching the RADIAS-R
1
Using the insulating bushings, insulating wash-
ers, screws, and the included screwdriver, attach
the RADIAS-R to the RD-KB.
Insulating washer
Insulating bushing
Screw
Insulating washer
Insulating bushing
Only attach the RADIAS-R when the arms are
down in their original position, as in the illustra-
tion above. Also, you must firmly tighten the
screws in all four locations.
Screw
Front panel
surface

Assembling the RADIAS-R and RD-KB

Raising the RADIAS-R
1
Grasp the handle with your left hand and raise
the RADIAS-R to the upright position.
Don't let go of the handle. The RADIAS-R may
fall down, injuring you.
Don't attempt to raise the RADIAS-R by grasping
the sides of the RADIAS-R . You may pinch your
fingers or hand and be injured.
2
With your right hand, move the tab (the location
marked by ) in the direction of the arrow to
lock the arm.
Don't grasp any part other than the tab. You may
pinch or otherwise injure your fingers or hand if you
do so.
unlocked
3
Make sure that the arm has locked, and then
release your left hand.
locked
5