Technical Data; Installation; Water Connection - IKEA RENLIG DWTI60 Bedienungsanleitung

ENGLISH

Technical data

Dimensions
Water supply pressure
Capacity (place settings)
Energy class
Washing class
Drying class
Noise (dB(A))
Average annual energy con-
2)
sumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 220 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rating
plate on the inner edge of the dishwasher door.

Installation

Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install it
under a counter (kitchen worktop or sink).

Water connection

This appliance has a special inlet hose for
water stop later defined as aqualock.
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
Width (cm)
Height (cm)
Depth (cm)
1) Minimum
Maximum
12
A
A
A
49
231
3520
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
If a repair is necessary, the appliance must be
easily accessible for the engineer.
Put the appliance adjacent to a water tap and
a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
If the hot water comes from alternative sources
of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4".
19
59,6
85,8-93,8
55,0