Küppersbusch ITE 127-8 Gebrauchs- Und Montageanleitung Seite 20

3. Open the door and push the appliance against the
side of the kitchen unit opposite to that of ap-
pliance hinges. Fasten the appliance with 4
screws (I) provided in the kit included with the
appliance.
C
D
E
4. Snap vent grille (B) and hinge cover (E) into
position.
Apply covers (C-D) on joint cover lugs and into
hinge holes.
Ha
Hc
PR266
5. Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
20
I
B
Hb
Hd
ca. 50 mm
ca. 50 mm
6. Place guide on the inside part of the furniture door,
up and down as shown in the figure and mark the
position of external holes. After having drilled
holes, fix the guide with the screws supplied.
Ha
Hc
PR33
7. Fix cover (Hc) on guide (Ha) until it clips into
place.
PR167
8. Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
90°
90°
8mm
Ha
Hb