Operating Sequence; Setting The Time - Electrolux EWF1440 Gebrauchsanweisung

Operating sequence

Before washing your first load of laundry, we
recommend that you run a cotton cycle at 90°C,
with the machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you have selected the prewash option, pour
detergent into the appropriate compartment marked
.
3. Measure out the additive
If required, pour fabric softener into the
compartment marked
«MAX» mark.
P1209
4. Select the desired programme
Switch the machine on turning the programme
selector dial to the desired position. To switch the
appliance off turn it to STOP.
STOP
Cottons
Cottons Economy
Synthetics
Gentle spin Delicates
Spin Handwash
Drain Wool
Rinses Silk
MINI 30
.
, without exceeding the
P1210
Switching the appliance for the first time.
LANGUAGE
When switching on the appliance for the first time
you must set the language in which you want the
indicators in the display to appear.
Important!
If the display is not showing any language, the
appliance has already been switched on once. In
such case, go to the chapter «Change language» if
you would like to change the language setting.
Example:
1. Press the CHANGE button until the desired
language appears in the display.
Language
ENGLISH
° T/Min. Options Change
Temp. C
2. Press the EXIT button to confirm the selection.
Einstellungen
° T/Min. Options Change
Temp. C
All indicators in the display will appear in this
language from now on.
When the appliance is switched on again all
indicators in the display will appear in this language.
Note:
If the undesired language has been set, press
contemporary T/Min. + OPTIONS buttons for about
2 seconds in order to change the language.
Follow the instructions as before.

SETTING THE TIME

You should set the time prior to the first wash and
when changing to and from daylight savings time.
See «Clock setting», Setup.
97
Sprache
DEUTCH
Exit
° T/Min. Options Change
Temp. C
A
Exit
B
Exit