Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
THE WASHING RESULTS AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and dull.
TECHNICAL DATA
Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The basket was not loaded
correctly, water did not touch
all surfaces.
The spray arm could not turn
freely because of incorrect ar-
rangement of the load.
The filters are clogged.
The filters are not correctly as-
sembled and installed.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the
cause.
You have set a washing pro-
gramme without a drying
phase.
The rinse aid dispenser is emp-
ty.
Width
Height
Depth
Refer to the rating plate
Voltage
Frequency
Minimum
Maximum
Cold water or hot water
electrolux 13
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Load the basket correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arm.
Make sure that the filters are
clean.
Make sure that the filters cor-
rectly assembled and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of deter-
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
220–240 V
maximum 60 °C
550 mm
438 mm
500 mm
50 Hz
0.04 MPa
1 MPa
Werbung
Kapitel
Inhaltsverzeichnis
