Turning The Engine Off; Starting The Appliance; Setting Operating Pressure And Flow Rate; Changing The Nozzle - Parkside PHDB 4 A1 Originalbetriebsanleitung

♦ Start the engine with the pull starter
this. If the engine does not start, pull the starter again.
♦ After starting, push the choke
NOTE
► The procedure described in this section is suitable for both a cold
start and a warm start.
Turning the engine off
♦ Run the appliance for a short while without load before you switch it
off so that the appliance can "aftercool".
♦ Move the On/Off switch
♦ Close the fuel tap

Starting the appliance

♦ Switch on the water supply.
♦ Start the engine with the trigger
NOTE
► You can remove the jet pipe
easier.
♦ Run the engine for 1 minute to warm it up.
Setting operating pressure and flow rate
■ The pressure and flow rate are fixed on this appliance and cannot be
changed.

Changing the nozzle

DANGER!
► Before changing the nozzle, switch off the appliance and pull the
trigger to depressurise the appliance.
♦ Remove the nozzle .
♦ Fit the new nozzle .
PHDB 4 A1
; pull firmly on the handle to do
back in (in the right position).
to the "OFF" position.
open.
or the nozzle to make starting

Use with a cleaning agent

WARNING!
► Switch off the appliance before making any adjustments or carrying
out maintenance work.
WARNING!
► Unsuitable cleaning agents can damage the appliance and the
object to be cleaned.
Use only recommended cleaning agents that are suitable for
high-pressure cleaners.
This appliance is suitable for operation with the cleaning agents
recommended by the manufacturer. The use of other cleaning agents
or chemicals can have a negative effect on the safety of the machine.
► The recommended cleaning agents are primarily those that are suit-
able for use with high-pressure cleaners. These are available in
DIY and car accessory stores.
♦ Hang the cleaning agent hose
♦ Replace the high-pressure nozzle with low-pressure nozzle (black).
–
0° nozzle – red:
Extremely strong, precise jet. Cleans only a small area.
Do not use for cleaning wood!
–
15° nozzle – yellow:
Strong 15° jet for intensive cleaning of small surfaces.
Use only on surfaces and materials that can withstand high pressures.
–
25° nozzle – green:
25° jet for intensive cleaning of larger surfaces.
–
40° nozzle – white:
40° jet for cleaning large surfaces.
–
Chemicals nozzle – black:
Low-pressure nozzle for the application of cleaning agents.
Recommended cleaning methods
–
Dissolving dirt:
Spray the cleaning agent sparingly and leave to work for 1–5 minutes
but do not let it dry.
–
Removing dirt:
Rinse off the dissolved dirt using a high-pressure jet.
After using with a cleaning agent
♦ Leave the appliance engine running and pull the trigger
1 minute to rinse itself.
in a container with cleaning agent.
for at least
GB │ IE │ NI │ 13
■