Safety Devices; Relief Valve; Safety Valve; Thermal Valve - Parkside PHDB 4 A1 Originalbetriebsanleitung

Safety devices

The safety devices are designed to protect the user and may not be de-
activated or repurposed.

Relief valve

■ If the hand spray gun is closed, the relief valve opens and the high-pres-
sure pump routes the water back to the pump suction side. This prevents
the permissible working pressure from being exceeded.
■ The relief valve is set and sealed at the factory. It may only be adjusted
by the customer service.

Safety valve

The safety valve opens if the permissible maximum allowable working
pressure is exceeded (see technical specifications); the water flows out.
The safety valve is set and sealed at the factory. It may only be adjusted
by the customer service.

Thermal valve

The thermal valve protects the high-pressure pump from impermissible
warming in circulation operation if the hand spray gun is closed.
The thermal valve opens if the maximum permissible temperature of 68°C
is exceeded and drains the hot water.

Before use

NOTE
► Exercise caution when unpacking, transporting and storing due to
the high weight of the machine.
► These activities should be carried out by two people.
► Make sure that the appliance is standing on a level and flat surface
while unpacking, and during assembly, storage as well as during
operation, inspection, maintenance and when at a standstill.

Fitting the handle

♦ Align the holes on the handle
frame. Fix it in place with two screws
5&
Allen key and the open end wrench

Fitting the hose holder

♦ Fit the hose holder onto the handle
two components.
♦ Fix the hose holder in place on the handle
5$
and four nuts .
10 │ GB │ IE │ NI
■
A
with the holes on the appliance
5$
and two nuts using the
5%
.
A
by aligning the holes in the
A
with four screws

Fitting the upper spray gun holder on the handle

♦ Use two screws , two washers
spray gun holder onto the handle
Fitting the lower spray gun holder on the tubular
frame
♦ Use two screws attach the lower spray gun holder
tubular frame .

Fitting the wheels

5#
♦ Push a washer onto the axle
♦ Push the axle from outside through the wheel
5#
washer on the axle .
♦ Now guide the axle with the wheel from the outside into the tubular
frame . Place another washer
place with the R-clip .
♦ Repeat the process on the opposite side.

Fitting the rubber feet

♦ Attach the rubber feet with the screw
onto the tubular frame .
5$
and two nuts to fit the upper
A
.
onto the
.
and place another
5#
onto the axle and secure it in
5@
, washer and nuts
PHDB 4 A1