Control Switches - Migatronic MIG 385 C MK III Betriebsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Assembly of the welding torch (C-model)

The welding torch is fitted to the central adaptor (pos.

2 page 14), and the connection is fastened by hand.

If the machine has a water module the two water

hoses are fitted to the quick release connectors for

water.

Wire feeding (C-model)

The wire roll combination to the chosen wire dia-

meter can be seen from the figure page 65. The

machine is delivered with one set of wire rolls etc. as

standard. Other sizes can be delivered. Only parts of

the same colour can be fitted together.

How to connect the separate wire feed unit

(S-model)

The machine is always delivered with a MWF 8 wire

feed unit. The plug kit for the MWF 11/21 wire feed

units can be mounted according the mounting

instructions which can be found together with the

plug kit (please look at page 66).

Adjustment of wire brake

The wire brake must ensure that the wire reel brakes

sufficiently quickly when welding stops. The required

brake force is depending on the weight of the wire

reel and the maximum wire feed speed. A brake

torque of 1.5-2.0 Nm will be satisfactory for most

applications.

Adjustment:

Dismount the control knob by placing a thin screw

driver behind the knob and thereafter pull it out

Adjust the wire brake by fastening or loosening

the self-locking nut on the axle of the wire hub

Remount the knob by pressing it back into the

groove.