Proper Use; Technical Data - Parkside PABS 18-2 SL Bedienungsanleitung

Introduction/Safety
Cordless 2 gear drill driver
PABS18-2 SL
For drilling and screwdriving into wood,
plastic and metal
Before you use it for the first time, it is essential that
you make yourself fully familiar with the functions of
the equipment and find out how to handle electrically
powered tools. Please read the following operating
instructions carefully along with the enclosed
safety advice . These instructions are to be con-
sidered as a constituent part of the product.

Proper use

í
This device is designed for drilling and screwing in-
to wood, plastic and metal. Use the device only as
described and for the indicated purposes. Any other
use or modification shall be deemed improper use
and could give rise to considerable dangers. The
manufacturer will not accept liability for loss or dam-
age arising from improper use.The tool is not intend-
ed for commercial use.
Features PABS 18-2 SL
í
Screwdriver /drill selector switch
Spirit level
Battery condition indicator
Ventilation air inlet
Forward/reverse switch
ON/OFF switch
Button for unlocking the battery
Battery pack
Torque selector
Keyless chuck
Fast charger
(Charging time only 50-60 minutes)
Green charge check light
Red charge check light
Contact
14 GB
PARKSIDE

Technical data

í
Cordless 2 gear drill driver PABS 18-2 SL
Nominal no-load
st
speed 1 gear:
Nominal no-load
nd
speed 2 gear:
Nom. d.c. voltage:
Chuck size:
Max. drill diameter:
Var. driver torque:
Max. drilling torque:
Sound level:
Vibration value:
Weight:
Fast battery charger JDA-22K
Charging current:
Charging time:
Battery pack
Nom. d.c. voltage:
Battery capacity:
Capacity:
Power consumption/Watt
The power consumption in watts changes with the
load. The measured power consumption during var-
ious types of use is e.g.:
nd
in 2 gear with a 3 mm
drill bit in softwood:
st
in 1 gear with a 10 mm
drill bit in (ST37) steel strip:
in 1st gear with a 20 mm
drill bit in softwood:
Power output/Torque/Newton metres (Nm)
The maximum torque is 18 Nm (soft screwing). The
power consumption can reach over 1000 W.
Do not overload the drill! As the speed of the motor
drops, the speed of the fan reduces and this may lead
to the motor overheating.
-1
n 0-500/min
0
-1
n 0-1400/min
0
18 V
1,0 - 10 mm
Steel: 10 mm,
Aluminium: 15 mm,
wood: 20 mm
1 - 8 Nm
18 Nm
74.35 dB (A)
2
2.5 m/s
2100 g
2600 mA
50-60 minutes
18 V
1500 mAh
27 Wh
090 watts
215 watts
330 watts