Installing The Unit (In-Dash Mounting) - Kenwood kdc-x7100dab Bedienungsanleitung

INSTALLATION/CONNECTION

Installing the unit (in-dash mounting)

Orientate the trim
plate as illustrated
before fitting.
Part list for installation
(A) Faceplate
(D) Wiring harness
30
ENGLISH
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
(B) Trim plate (C) Mounting sleeve
(E) Extraction key
How to remove the unit
1 Detach the faceplate.
Do the required wiring.
2 Fit the catch pin on the extraction keys into the holes on both
( 31)
3 Insert the extraction keys deeply into the slots on each side,
Dashboard of
your car
Wiring for ISO connectors
Pin
A4
A5
A7
A8
B1
B2
B3
B4
B5
B6
B7
B8
* 1
: ( 31).
sides of the trim plate, then pull it out.
then follow the arrows as shown on the illustration.
( 31)
Color and function (for ISO connectors)
Yellow : Battery
Blue/White * 1
: Power control
Red : Ignition (ACC)
Black : Earth (ground) connection
Purple ]
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
Purple/black [
Gray ]
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
White ]
: Front speaker (left)
For 3-way crossover: Mid range speaker (left)
White/black [
Green ]
: Rear speaker (left)
Green/black [ For 3-way crossover: Tweeter (left)