Kenwood kdc-x7100dab Bedienungsanleitung Seite 20

BLUETOOTH®
NUMBER DIAL 1 Turn the volume knob to select a number (0 to 9) or character ( , #, +).
2 Press S / T to move the entry position.
1
Repeat steps
3 Press the volume knob to call.
VOICE Speak the name of the contact you want to call or the voice command to control
the phone functions. ( Make a call using voice recognition)
BATTERY LVL LOW/MID/FULL * : Shows the strength of the battery.
NO SIGNAL/SIGNAL LVL LOW/MID/MAX * : Shows the strength of the current received signal.
* Functionality depends on the type of the phone used.
Make a call using voice recognition
1 Press and hold to activate the voice recognition of the connected
phone.
2 Speak the name of the contact you want to call or the voice command
to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of iPhone.
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [CALL HISTORY], [PHONE BOOK], or
[NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone number.
4
Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER DIAL] in step
store a blank number.
16
ENGLISH
2
and until you finish entering the phone number.
Make a call from memory
1 Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected/activated or
follow the instructions stated on the selected item.
4
Press and hold
To return to the previous setting item, press
BT MODE
PHONE SELECT Selects the phone or audio device to connect or disconnect.
"*" appears in front of the device name when connected.
" " appears in front of the current playback audio device.
AUDIO SELECT
• You can only connect a maximum of two Bluetooth phones and
one Bluetooth audio device at any time.
DEVICE DELETE 1 Turn the volume knob to select a device to delete, then press the
knob.
2 Turn the volume knob to select [YES] or [NO], then press the
knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat steps
2 and 3 Press the volume knob to confirm.
to exit.
.
1 2
and until you finish entering the PIN code.
Default: XX