Herunterladen Inhalt Inhalt Diese Seite drucken

Safety; Export; Accessories - ergoline CLASSIC 8000 ULTRA Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für CLASSIC 8000 ULTRA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the nation-
al regulations.
1)
The electrical installation is to be fitted with an easily accessible
all pole isolating device (master switch) on the building side,
complying with overvoltage category III. This means that each
pin shall have a contact opening width complying with the con-
ditions of overvoltage category III for full isolation.
If it is connected via a plug and socket, the plug system used
shall comply with EN 60309-1/A11; 5-pin; 400 V AC -
(16A or 32A).
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed person-
nel.
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be re-
moved or deactivated which can impair the safe operation of the de-
vice!
• The device may only be operated in proper condition!
1) In Germany: VDE regulations
• A timing device must be designed so that the device is automatically
switched off at the latest after 110% of the selected operating time
even when the controller fails. The device operating time must be
dual controlled with a timing device to the standards EN 60335-2-27
and A1 2000 Section 22.108 and 22.109.
• Before putting a tanning device into operation, the transport pallet
must be removed from under the device. Danger of overheating by
obstruction of the air routing.
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The manu-
facturer shall bear no liability for damage or injuries resulting from
such actions.

Export

We emphasise that these devices are intended for the European market
and must not be exported to nor operated in the USA or Canada!
The manufacturer shall assume no liability whatsoever in case of non-ob-
servance! We explicitly emphasise that high liability risks may occur for
the exporter an/or the operator in case of non-observance.

Accessories

An overview of the possible accessories is provided in the sales docu-
mentation and the planning manual. See page 49 for a selection of these.
33

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis