Connecting The Water Supply - Salvis ProfiLine Betriebsanleitung

U-channel
Front cover
Screw
10.6

Connecting the water supply

● Observe the regional conditions and the "Technical Rules for Drinking Water Installations
EN 1717"!
● Rinse through the water pipes in the building system and supply hoses before connecting.
● The appliance must be connected to an easily accessible water stopcock.
● We recommend connecting the water supply to the hot water pipe so that the appliance heats up
more quickly.
● Connect to a hot water supply of no more than 60°C.
● Water pressure: min. 200 kPa (2 bar) dynamic, maximum 600 kPa (6 bar) static..
● In order to compensate for pressure fluctuations and to avoid spraying when filling, fit a pressure
reducing valve locally and set to 200 kPa.
● To reduce limescale build-up in the appliance where the water hardness is greater than 10° dKH,,
we recommend that you install a water softener in the water supply.
● There must be no connecting pipes made from galvanized iron or similar material between the
water softening device and the appliance, otherwise there is a risk of rust forming.
● Observe the installation and user manuals for the water softener connected.
● The supply hose may not be kinked or crushed.
● Check that all connections are watertight.
Cage
nut
U-washer
Install front cover
. Install the cage nut.
. Insert the front cover below the U-channel.
. Attach the front cover with four screws.
en
51 / 56