Gastroback VITAL MIXER PRO Bedienungsanleitung Seite 64

CAUTION:
›0‹). The measuring scale should face forward and the handle should point to the
right.
The appliance can only operate when the Start-/Stop-button or a program is activa-
ted and the power cord is plugged in.
5. After inserting all the ingredients in the blender jug, place the lid (2) (with the
tongue from the lid into the drain of the blender jug) onto the blender jug by
pushing it down.
6. Close the opening of the lid with the inner lid (1). The inner lid has two small
guide pins that fit into the corresponding holes on the refill opening of the lid.
Turn the inner lid after insertion clockwise. The inner lid positioned securely after
latching with a ›click‹ and no longer can be raised.
ATTENTION:
it and if possible only hold on to the socket.
Important: Do not tighten the blade assembly housing with force or too tight to
avoid damaging the appliance or the sealing ring.
ATTENTION:
housing and the sealing ring are in proper position and firmly locked before putting
the blender jug on the motorblock. Without the blade assembly housing the bottom
of the blender jug is open. Spilled liquids might run right into the motor. Always
wipe off spilled liquids immediately. Never let any liquids run into the motorblock
or underneath it to avoid electric shock. When liquids are spilled on the motor
housing, immediately unplug the appliance and dry the motor housing to avoid
risk of electric shock or fire. Do not attempt to operate the appliance, when liquids
are on or in the motor housing.
ATTENTION:
Never touch the drive gear when the plug is connected to the power outlet.
ATTENTION:
base or onto the motor base. If liquid has run over the housing of the motor base,
turn off the power immediately and unplug the power cord from the outlet. Wipe
the liquid then with a dry cloth, then dry the housing well.
64
Make sure that the blender is switched off (rotary switch setting
The blades of the knifes are very sharp. Pay attention handling
Ensure the blender jug is leak-proof and that the blade assembly
Never place only the socket or the knife unit on the motorblock.
Take care always to ensure that no liquids run into the motor