Trouble Shooting - Gastroback 41002 Bedienungsanleitung

TROUBLE SHOOTING

The Design Mixer Advanced Plus is reliable and robust and handling it with care it will
operate properly. For the case that problems show up you can solve the problems on
your own using the trouble shooting guide.
WARNING: Only use the appliance for the intended use. For attendance and repair
take the appliance to an authorised service centre.
Problem Solution
Motor doesn't start Check that the power plug is securely inserted into the power outlet and switched on. Check
or blade doesn't that the blender jug and lid are securely locked into position. Check that the Power-button and
rotate selected function or speed setting is illuminated. Be sure to press only one speed or function
button at a time.
The motor stucks or Use a higher speed for processing. If necessary (because the blender jug is overloaded) pour
slows down out part of the content of the blender jug. Chop hard ingredients such as nuts or chocolate
before putting them into the blender jug.
The motor stops or Turn the appliance off, if the motor stops all of a sudden or stalls during operation to avoid
you can not turn the overheating. Go through following checking list:
motor on again – The appliance automatically shuts off after operating for 2 minutes. If you want to operate
– Take the blender jug off the motorblock and clear out firmly bounded food that blocks the
– Chop hard ingredients such as nuts or chocolate before putting them into the blender jug. If
– ATTENTION: Do not try to mix ingredients of very hard consistency or ingredients which are
The bottom of the Turn the appliance off and pull the plug out of the power outlet. Empty the blender jug. Clean
blender jug untigh- and dry the motorblock. If any ingress of moisture into the motorblock or through the louvre
tens during operati- take the appliance for technical maintenance and repair to an authorised specialised reparation
on; liquid leaks. shop.
Ensure the blender jug is properly assembled.
TIP: Before filling liquid into the blender jug check if the blender jug is leak-proof by filling it
with water. Check the sealing ring. If necessary replace damaged parts by original spare parts
of the manufacturer.
It is not possible to Empty the blender jug. Disassemble the blender jug and check if there are crusts or damages
get the blender jug on the single parts. Clean the parts if necessary.
leak-proof; Liquid
Replace damaged parts by original spare parts of the manufacturer. Assemble the blender jug
leaks from the bot-
according to the instructions.
tom of the blender
ATTENTION: Never use the appliance with improper or damaged parts. Only use spare parts
jug.
provided and made by the manufacturer. Contact your vendor for help.
70
again, unplug the appliance, wait 1 minute and plug in again.
blade using a spoon. Do not use force to avoid damaging the blade.
necessary (because the blender jug is overloaded) pour out part of the content of the blen-
der jug and try to restart the motor using a higher speed.
too big in size to avoid overloading the motor. Do not overfill the blender jug. Process very
hard food in more then one go. The mixer is not intended for chopping nuts with shell,
bones or simular hard ingredients.