Gastroback 41002 Bedienungsanleitung Seite 59

Note:
The blade assembly housing has two small guiding pins that fit in the matching gaps
of the base of the blender jug. The blade assembly housing is in the right position if it
seats solidly onto the base of the blender jug and when you can twist it anticlockwise.
appliance or the sealing ring. Ensure the sealing ring is in position and did not fall into
the blender jug when assembling.
ATTENTION: Ensure the blender jug is leak-proof before putting the blender jug on the
motorblock. Always wipe off spilled liquids immediately. Never let any liquids run into
the motorblock or underneath it to avoid electric shock. When liquids are spilled on the
motor housing, immediately unplug the appliance and dry the motor housing to avoid
risk of electric shock or fire. Do not attempt to operate the appliance, when liquids are
on or in the motor housing.
ATTENTION: Never place the holder or the blade only on the motorblock. Never
touch the drive gear when the plug is connected to the power outlet. Without the blade
assembly housing the bottom of the blender jug is open. Spilled liquids might run right
into the motor.
ATTENTION: When liquids are spilled on the motor housing, immediately unplug the
appliance and dry the motor housing to avoid risk of electric shock or fire. Do not attempt
to operate the appliance, when liquids are on or in the motor housing.
3. Place the proper assembled blender jug onto the motorblock. Turn the blender jug
until it locks onto the motorblock. The handle of the blender jug should be positioned
to the right hand side of the appliance in order to see the measuring scale.
The screen will turn on as soon as the plug is plugged into the power outlet, the
blender jug is securely locked onto the motorblock and the appliance is switched on
by pressing the power button.
4. Place the clear refill lid onto the opening of the blender lid.
Note:
The refill lid has two small guiding pins that fit in the matching gaps of the lid. Twist it
clockwise ¼ of a turn until firmly locked into position. You can hear it click when the
refill lid is in proper position.
The blade assembly housing and the
sealing ring should be properly con-
nected to seal the bottom of the blender
jug. Otherwise ingredients will run right
into the motorblock.
IMPORTANT:
Do not tighten them with
force or too tight to avoid damaging the
59