Assembly; Supply Line Connection - SIMALFA Primus Betriebsanleitung

► When spraying materials, never hold hands or other body parts
in front of the pressurized nozzle of the spray gun. - Risk of injury.
► Never point the spray gun at persons or animals
- Risk of injury.
► Follow the processing and safety instructions of the manufacturers of spraying
materials and cleaning agents. Especially aggressive and caustic materials
may cause health damages.
► Particle-conveying discharged air must be kept away from the working area
and operating personnel. Nonetheless, be sure to wear stipulated respirators
protection and work clothes when processing materials with the spray gun.
Airborne particles can endanger your health.
► Wear eye protection during painting and cleaning.
► Wear hearing protection in the working area of the spray gun. The sound level
generated by the spray gun is approx. 83 dB (A) .
► Always make sure during operation, especially after assembly and mainte-
nance work, that all nuts and bolts are securely tightened.
► Use only original spare parts because the manufacturer can only guarantee
safe and flawless function for such original parts.
► Always relieve the pressure from the spray gun after work is completed.
► If you have questions about the safe use of the spray gun as well as the mate-
rial used in it, please do not hesitate to contact the manufacturer.
4

Assembly

4.1

Supply line connection

Attention
The air pressure at the gun may not exceed 8 bar since a reliable and safe opera-
tion of the spray gun is otherwise not ensured.
Warning
Material and air hoses mounted on a hose nipple must be secured with a hose
clamp in addition.
Note
The gun must be flushed before use to prevent contamination of the spraying mate-
rial.
26
Design: Material connection lower
1.
2.
3.
4.
material
connection
lower
5.
The spray gun can then be put into operati-
air connnection
on
Design: Material connection upper
material
connection
1.
upper
2.
3.
4.
5.
The spray gun can then be put into operati-
on
air connnection
27
Connect the air hose to the air connec-
tion nipple (item 35) of the spray gun.
Fasten the material inlet hose to the
material inlet (item 37) of the spray gun.
Lift the free flowing system container to
the desired height.
To let the air contained in the material
hose escape, actuate the trigger
(item 31) until a uniform jet emerges
from the nozzle; now the trigger can be
unleashed again.
Regulate the desired air pressure by
using the adjusting screw (air flow rate
adjustment, item 29).
Connect the air hose to the air connec-
tion nipple (item 35) of the spray gun.
Fasten the material inlet hose to the
material inlet (item 36) of the spray gun.
Lift the free flowing system container to
the desired height.
To let the air contained in the material
hose escape, actuate the trigger
(item 31) until a uniform jet emerges
from the nozzle; now the trigger can be
unleashed again.
Regulate the desired air pressure by
using the adjusting screw (air flow rate
adjustment, item 29).