Initial Start-Up; Operation - Kärcher BR 30/4 C Bp Bedienungsanleitung

1 LED flashes slowly: below 28% re-
maining capacity
1 LED flashes quickly: Fault
19 Brush roller
20 Vacuum bar
21 Unlocking button for the changeable brush
22 Lock
23 Cover waste water tank
24 Filling level display

Initial Start-Up

Figure 2, see cover page
 Insert tube into the opening of the appli-
ance at the end of the handle.
 Press down and slide the handle into
the appliance until it clicks.
 Align the cable in the appliance and at-
tach the lid as shown on the supple-
ment sheet.
 Charge the battery.

Operation

Fill fresh water reservoir
CAUTION
Risk of damage. Only use the recommend-
ed detergents. With other detergents, the
operator bears the increased risk regarding
the operational safety, risk of accident and
reduced service life of the appliance. Only
use detergents that are free of solvents, hy-
drochloric acid and hydrofluoric acid.
Follow the safety instructions for using de-
tergents.
Note:
Do not use highly foaming detergents.
Observe the dosing notes.
Recommended detergents:
Application
Everday cleaner, al-
kali-based
Everyday cleaner,
acidic, for sanitary
applications, swim-
ming pools, etc. Re-
moves limestone
deposits.
Wipe care EXTRA RM 780
Floor base cleaner,
acidic
Detergent Dosage
RM 743 0.5 - 2.0%
RM 738 0.5 - 3.0%
0.5 - 2.0%
RM 751 1.0 - 25%
 Remove the fresh water reservoir from
the appliance.
 Open the cover of the fresh water reser-
voir.
 Pour in water/detergent mixture. Maxi-
mum temperature of the liquid 50 °C.
 Close the cover of the fresh water res-
ervoir.
 Insert the fresh water container into the
appliance.
Insert the battery
Figure 3, see cover page
 Insert the battery into the battery com-
partment and push in until it locks into
place.
ATTENTION
Risk of damage to the floor covering. The
cleaning method for heavy soiling must
only be used on floors suitable for this kind
of cleaning.
Risk of damage to the fresh water pump if it
runs dry because of empty fresh water
tank. Monitor the filling level display and
switch the water pump switch off if the fresh
water tank is empty.
Normal soiling
 Move the suction bar lift pedal to posi-
tion „suction off" (Fig. 4 - position "1/
ON", see inside front cover).
 Press the park position release and
swivel the handle toward the rear.
 Press the switch for brushing/vacuum-
ing operation.
 Activate the water pump switch.
 Move the appliance over the surface to
be cleaned.
Severe soiling
ATTENTION
Risk of damage to the floor covering. The
cleaning method for heavy soiling must
only be used on floors suitable for this kind
of cleaning.
– 3
EN
Cleaning
13