Accessories And Spare Parts; Warranty; Technical Data - Kärcher HD 6/15 M Bedienungsanleitung

Have electrical components checked and repaired by
the authorised Customer Service.
In case of any malfunctions not mentioned in this chap-
ter, contact the authorised Customer Service when in
doubt or when you have been explicitly advised to do
so.
Device does not start
 Check the power cable for damage.
 Check the mains voltage.
 If the device overheats:
a Set the power switch to "0".
b Allow the device to cool for at least 15 minutes.
c Set the power switch to "1".
 Contact Customer Service in the case of electrical
faults.
Device does not reach required pressure
 Check the size of the nozzle and compare with the
required size specified in the "Technical data" sec-
tion.
 Vent the device, see section "Venting the device".
 Clean the sieve in the water connection.
 Check the water supply volume and compare with
the required volume specified in the "Technical data"
section.
 Clean the nozzle.
 Contact Customer Service if necessary.
Pump leaking
Up to 3 drops of water per minute are permissible.
Electrical connection
Mains voltage
Phase
Power frequency
Connection output
Protection class
Power protection (slow-blowing)
Extension cable, 30m
Water connection
Feed pressure (max.)
Input temperature (max.)
Input amount (min.)
Suction height (max.)
Performance data of device
Nozzle size of standard nozzle
Operating pressure
Operating pressure (max.)
Water flow rate
High-pressure gun recoil force
Dimensions and weights
Typical operating weight
Length
Width
Height of push handle, bottom, (top) mm
18
 In case of more serious leaks, have the device
Pump knocking
 Check the water supply line for leaks.
 Vent the device, see section "Venting the device".
 Contact Customer Service if necessary.
Detergent dosing volume too low
 Refill the foam nozzle cup.
 Plug a larger blender onto the suction hose.
 Check the suction hose and foam nozzle for deter-
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)

Technical data

HD 6/15 HD 6/15
M MX
V 230 230
~ 1 1
Hz 50 50
kW 3.1 3.1
IPX5 IPX5
A 16 16
2
mm 2.5 2.5
MPa 1 1
°C 60 60
l/min 12 12
m 0.5 0.5
-- 033 033
MPa 15 15
MPa 22.5 22.5
l/min 9.3 9.3
N 21.3 21.3
kg 30 33
mm 455 455
mm 400 400
700 890
(970) (970)
English
checked by Customer Service.
gent deposits. Remove deposits using lukewarm
water.

Accessories and spare parts

Warranty

HD 6/15 HD 7/17 HD 7/17
M PU M MX
230 400 400
1 3 3
50 50 50
3.1 4.2 4.2
IPX5 IPX5 IPX5
16 16 16
2.5 2.5 2.5
1 1
60 60 60
12 12 12
0.5 0.5 0.5
033 038 038
15 17 17
22.5 25.5 25.5
9.3 11.5 11.6
21.3 21.3 21.3
25 32 35
290 455 455
300 400 400
565 700 890
(970) (970)
HD 7/17 HD 7/
M PU 14-4 M
400 230
3 1
50 50
4.2 3.4
IPX5 IPX5
16 16
2.5 2.5
1 1
60 60
12 12
0.5 0.5
038 043
17 14
25.5 21
11.6 11.5
21.3 21.3
27 39
290 455
300 400
565 700
(970)