Using The Parking Aid - Waeco MagicWatch MWE900 Bedienungsanleitung

Using the parking aid

10 Using the parking aid
Supplementary to fig. j
The sensors are automatically activated when you engage the reverse gear
with the ignition on or the engine running. An activation signal sounds (two
short beeps).
As soon as there is an obstacle within the detection range, a repeated signal
tone is emitted.
As you approach, the tone sequence changes, depending on the zone in
which the obstacle is, thus indicating the distance.
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
Caution
a
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are manoeu-
vring:
when manoeuvring, the device first indicates an obstacle and the
tone sequence speeds up normally (e.g. from slow to medium).
Suddenly the signal tone slows down, or no obstacle is indicated at
all.
This means that the original obstacle is in the blind spot of the sen-
sors (construction-related characteristic), and it is possible to hit it.
20
MagicWatch MWE910