DS KPA08EP-05 Gebrauchsanweisung Seite 30

EN
Cleaning turbo nozzle
07504_DE-EN-FR-NL_A5_V1.indb 30 07504_DE-EN-FR-NL_A5_V1.indb 30
30
6. If the fi lter unit is inserted correctly in the dust container,
the upper arrow points towards the lower arrow of the
closed lock symbol (see picture).
7. To remove the fi lter unit, turn the dust container lid un-
til the upper arrow points towards the lower arrow of the
open lock symbol.
8. Pull the fi lter unit up and out.
9. Clean the dust container and the fi lter unit if
necessary with a damp cloth and mild deter-
gent. Then wipe with a dry cloth.
10. Make sure when cleaning that the HEPA fi lter
does not get wet. You can read about how to
clean the HEPA fi lter in the next "Cleaning the
HEPA Filter" section.
11. To put the dust container and the fi lter unit back together
again, you must insert the fi lter unit in such a way that the
upper arrow points towards the open lock symbol.
12. Turn the dust container lid until the upper arrow points
towards the closed lock symbol and locks in place.
13. Insert the dust container back into the vacuum cleaner.
The dust container must be heard to engage in place.
1. To make it easy to clean the turbo nozzle, you can open
the nozzle: To do this, twist the ring on the end piece of the
nozzle anticlockwise.
2. Carefully take off the top housing part. Now you can
remove hair, dust etc. from the brush.
3. After cleaning, put the nozzle back together again and turn
the ring in the clockwise direction until it clicks audibly into
place.
18.08.2015 15:51:57 18.08.2015 15:51:57