Specifying Cue Points - Sony MDS-DRE1 Bedienungsanleitung

Selecting a Track
To listen to tracks 9 through 32
Press BANK to switch to a different group (BANK) of
tracks before pressing a pad.
The current BANK number is shown in the display.
Each BANK assigns another group of 8 tracks to the pads:
BANK 1 n Tracks 1~8
(Track 1 = Pad 1, Track 2 = Pad 2, etc.)
BANK 2 n Tracks 9~16
(Track 9 = Pad 1, Track 10 = Pad 2, etc.)
BANK 3 n Tracks 17~24
(Track 17 = Pad 1, Track 18 = Pad 2, etc.)
BANK 4 n Tracks 25~32
(Track 25 = Pad 1, Track 26 = Pad 2, etc.)
z You can also start playback by pressing PLAY/PAUSE after
inserting the MD
In this case, playback starts from track 1.
To play other tracks, turn AMS.
To Do the following:
Stop playback Press STOP.
Pause playback Press PLAY/PAUSE. Press again
to start playback again from the
point at which it was paused.
Skip to next track Turn AMS to the right.*
Skip back to beginning of Turn AMS to the left.*
current or previous track
Eject the MD Stop playback, then press
§ EJECT on the front panel.
* In addition to skipping to the beginning of a track, you can also
set AMS to skip to any cue points you may have specified.
Use the Setup Menu to specify the AMS (JOG) mode.
For details, see "Specifying Cue Points" below.
To stop playback automatically at the end
of each track
Press SINGLE PLAY to light the "1" indicator.
Playback stops automatically at the end of each track.
To cancel the single play mode, and have playback
continue to the next track, press SINGLE PLAY again so
that the "1" indicator goes out.
12 GB

Specifying Cue Points

A cue point is a temporary "index" you can use to locate a
specific point in a track. You can specify one cue point for
each track.
EDIT/NO
CUE
PLAY/PAUSE
1
Start playing the track containing the desired
point.
To move quickly toward the desired point
Hold down 0 (fast reverse) or ) (fast forward) .
2
Press PLAY/PAUSE to pause at the desired point.
The PLAY/PAUSE indicator blinks.
To check the point
Hold down CUE.
The unit repeats a 3 second section starting from the point
playback was paused.
To adjust the point
• Hold down CUE and turn the scrub dial.
The beginning of the 3 second section moves in sync with
the motion of the scrub dial.
• Turn the scrub dial (without holding down CUE).
The sound plays in sync with the motion of the scrub dial.
(Sound may not be produced immediately when turning
the dial backwards.)
3
Press PLAY/PAUSE again to resume playback.
The PLAY/PAUSE indicator lights and the unit stores
the point specified in step 2 as a cue point.
Recalling the cue point
1
Press CUE recall the cue point.
CUE lights up, PLAY/PAUSE blinks, and the unit
immediately skips to and pauses at the previously
specified cue point.
2
Press PLAY/PAUSE to start playback from the cue
point.
AMS
0/)
Scrub dial