Herunterladen Inhalt Inhalt Diese Seite drucken

Brusa NLG5 Betriebsanleitung Seite 5

Vorschau ausblenden Andere Handbücher für NLG5:
Inhaltsverzeichnis

Werbung

Betriebsanleitung NLG5
12.2003-NLG5xx_179_ab Nr25
Zu Ihrer Sicherheit
Lassen Sie das Gerät durch einen Fachmann im
Fahrzeug installieren und in Betrieb nehmen.
Öffnen Sie keinesfalls das Gerät ohne vorherige
Rücksprache mit dem Werk.
Trennen Sie niemals den Batterieausgangs-Stecker
vom Gerät, ohne vorher die Batterie fahrzeugseitig
abzuklemmen.
Stecken Sie den Netzstecker erst ein, wenn eine si-
chere Verbindung zwischen Batterie und Gerät ge-
währleistet ist (Ausnahme: Die Kennlinien-
Programmierung mit beiliegendem seriellen An-
schlusskabel kann ohne Batterie erfolgen).
Ziehen Sie den Netzstecker, bevor die Batterie vom
Gerät getrennt wird.
Betreiben Sie das Gerät nie an einer Steckdose
ohne Schutzleiter-Anschluss.
Verwenden Sie grundsätzlich einen Fehlerstrom-
Schutzschalter (FI) in der Netzzuleitung.
Begrenzen Sie die Netzstromaufnahme des Lade-
gerätes auf die zulässige Belastbarkeit der Netzin-
stallation (siehe 6.2.11).
Wickeln Sie eine vorgeschaltete Netzkabelrolle
immer ganz ab, da sie sonst überhitzen und Feuer
fangen kann.
Ziehen Sie nach Beendigung der Ladung und bei
Nichtgebrauch den Netzstecker.
5 / 47
For your safety
Have the unit installed and made operational by a
skilled professional.
Do not open the unit without contacting the
manufacturer beforehand.
Never pull the battery plug out of the unit without
breaking the battery connection on the vehicle side
beforehand
Do not plug in the mains connector unless a safe
connection between battery and charger has been
established (exception: you may program the
charging profile connecting the charger to the PC
by using the serial interface cable; you don't have to
connect the battery for that).
Remove the mains plug from the mains outlet
before breaking the battery circuit.
Never operate the unit at a mains outlet without
protective earth connection.
Always use a GFI (Ground Fault Interruption) circuit
in mains supply.
Limit the mains power input of the charger to the
maximum allowed load of the mains installation
(see 6.2.11).
Always unreel heavily loaded cable bobbins
completely, otherwise they might overheat and
cause a fire.
Always disconnect mains power line after charging
and generally when the device is not in use.
User's manual NLG5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis