HP B109 Bedienungsanleitung Seite 7

Troubleshooting
You can re-enable your firewall application after installation is complete. Make sure the following files
are included in the exceptions list of the firewall:
• C:\Program Files\Hp\Digital Imaging\bin\hpqtra08.exe.
• C:\Program Files\Hp\Digital Imaging\bin\hpiscnapp.exe.
• C:\Program Files\Hp\Digital Imaging\bin\hpqdstcp.exe.
• C:\Program Files\Hp\Digital Imaging\bin\hpqkygrp.exe.
• C:\Program Files\Hp\Digital Imaging\bin\hpqste08.exe.
• C:\Windows\System2\hpzinw12.exe.
• C:\Windows\System2\hpzipm12.exe.
Tip: Configure your firewall software to allow communication over UDP port 427.
Step 4: Use the advanced search feature.
1. Print a network configuration report using the following instructions:
a. Press button next to Scan.
b. Press button next to Wireless Menu.
c. Press button next to Wireless Settings.
d. Press button next to Print Network Configuration Page.
2. Identify the IP address of the HP Photosmart from the network configuration report.
. Use the advanced search option available during software installation, then click on Search by IP address
and enter the product's IP address.
Other network problems after software installation
If the HP Photosmart has been successfully installed, and you are experiencing problems such as not being
able to print, try the following:
• Turn off the router, product, and computer, and then turn them back on in this order: router first, then the
product, and finally the computer. Sometimes, cycling the power will recover a network communication
issue.
• If the previous step does not solve the problem and you have successfully installed the HP Photosmart
Software on your computer, run the Network Diagnostic tool.
To run the Network Diagnostic tool
> In the Solution Center, click Settings, click Other Settings, and then click Network Toolbox. On the
Utilities tab, click Run Network Diagnostics.
7