Eibenstock EDS 125 Originalbetriebsanleitung Seite 18

▪
Check the accessories before use. Do not use any products which are
broken, cracked or damaged in another way.
▪
Before use, make sure that the tool is correctly fixed and fastened. Let it
run idle for about 30 seconds in a safe position. If considerable vibrations
occur or if other defects are recognised, switch off immediately.
▪
Always lead the mains and extension cable as well as the extraction hose
to the back away from the machine.
▪
Make sure the wheel is not contacting the workpiece before the switch is
turned on.
▪
Wait until the wheel attains full speed before cutting.
▪
Attention! The tool still runs for a little while after the machine was
switched off.
▪
Before setting the tool down after completing a cut, be sure that the wheel
has come to a complete stop.
▪
Do not stop the wheel by lateral pressure on the disc.
▪
Never carry the machine at its cable.
▪
Do not touch rotating parts.
▪
Persons under 16 years of age are not allowed to use the tool.
▪
During use, the operator and other persons standing nearly have to
wear suitable ear protectors, a dust mask, protection goggles as
well as protective gloves.
▪
Make sure that persons in the work space are not endangered by parti-
cles flying around.
▪
Keep the handles dry, clean and free of oil and grease.
▪
Power tools have to be inspected by a specialist in regular intervals.
For further safety instructions, please refer to the enclosure!
E l e c t r i c a l C o n n e c t i o n
Attention!
▪
!
The PRCD protective switch must not lay in water.
▪
PRCD protective switches must not be used to switch the
tool on and off.
▪
Before starting your work, check the proper function by
pressing the TEST button.
The EDS 125 is designed in protection class II.
To protect the operator, the EDS 125 may only be operated
in wet cutting if a residual current device is available. For
this reason, the device is supplied with a residual current
device (PRCD) integrated in the cable as standard.
17