Scheppach SG7100x Originalbetriebsanleitung Seite 32

Operating mode S2 (short-term operation)
The machine may only be operated at maximum power
for a brief time. Then, the machine must be brought to
a standstill for a period of time so that it is not allowed
to heat up.
Noise
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA
7. Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the device by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering, please provide our article number,
the type and year of manufacture for your device.
m DANGER!
The device and the packaging are not children's
toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
8. Layout
m ATTENTION!
Always make sure the device is fully assembled before
commissioning!
Your machine is not fully assembled.
32 | GB
8.1 Mounting the transport wheels (Fig. 3)
1. Feed the wheel axle (19a) through the wheel (19).
2. Now push the washer onto the wheel axle (19a)
and slide the wheel axle (19a) with the wheel (19)
into the hole of the lug (a).
3. Fix each of the wheel axles in place with a spring
split pin (19c).
8.2 Mounting the support feet (Fig. 4)
1. Refit the support foot (11) to the bottom frame
strut.
2. Fix the support feet with two nuts each (11a).
95.8 dB
8.3 Mounting the transport handles (Fig. 5)
75.76 dB
1. With the pin (10a) you can fix the transport han-
1.5 dB
dle (10) in position.
9. Before commissioning
Electrical safety
Prior to use, the power generator and its electrical
equipment (including lines and plug connectors) should
be checked to ensure that there are no defects.
Never connect the power generator to the mains (sock-
et).
The power lines to the consumer must be kept as short
as possible.
m DANGER!
Risk of fire and explosion!
When filling, fuel may ignite and even explode. This
can lead to severe burns or death.
- Switch off the engine and let it cool down.
- Keep heat, flames and sparks away.
- Only fill up with fuel outdoors.
- Wear protective gloves.
- Avoid contact with skin and eyes.
- Start the device at a distance of at least 3 m from
the fuel filling point.
- Watch out for leaks. If petrol is leaking, do not start
the engine.
m WARNING!
Health hazard!
Inhaling petrol/lubricant vapours may lead to severe
health damage, loss of consciousness and, in extreme
cases, to death.
- Do not inhale petrol/lubricant vapours.
- Operate the device outdoors only.
www.scheppach.com