Troubleshooting - Silverline 748850 Bedienungsanleitung

GB
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the machine's service life. Clean the body of your machine with a soft
brush, or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant

Troubleshooting

Problem
No function when Hand Controller
(3) is operated
Cable (13) reel
extends/retracts in the
wrong direction
Motor seems underpowered, or is
operating slowly
Motor runs but the Cable (13) does
not extend/retract
Cable (13) cannot be pulled perfectly
straight
Cable (13) is frayed
10
Possible cause
No power
Defective Hand Controller
Cable installed to Drum (11) in the wrong direction
Winch Assembly (8) installed to Mounting Bracket (17) in
wrong orientation
Weak battery
Poor power supply from loose connections or corroded
terminals
Incorrect power cables
Clutch is disengaged
Cable has been kinked
Cable has been subject to external abrasive damage
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
Solution
Check power supply
Replace the Hand Controller at an authorised Silverline service centre
Remove Cable and reinstall in the correct direction
Remove Winch Assembly and reinstall to Mounting Bracket in the correct orientation
Recharge battery. If problem persists, try running the engine whilst using the winch
Check to ensure all terminals and connections are in good condition. Replace if
necessary
Only use cables of the correct rating
See 'Clutch operation' for information on clutch operation
Cable is no longer safe for use, discard and replace
Cable is no longer safe for use, discard and replace