Gadnic MW-801C Bedienungsanleitung Seite 4

Parts
Using your garment steamer
Before first use
Remove any sticker or protective cover from the steam head.
Unwind and straighten the cord before use.
When operating the garment steamer for the first time, allow it to steam for a few minutes. this will remove any
impurities and odours that might have been left by the manufacturing process.
When operating the garment steamer for the first time, you may want to try the steamer on an old piece of fabric
before steamer on an old piece of fabric before steaming your garment.
Warning: to avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the
same circuit as your garment steamer when it is in use.
Note: when unpacking the garment steamer, check to see you have received all the items listed in the parts list,
before discarding the packaging.
Assembling/operating your garment steamer
1. Press the water tank release button, pull out the water tank, open the water inlet cover and fill tap water into the
water tank until it reaches the MAXIMUM level (see flg.1).always ensure the water tank is at least a third full.
Do not exceed the MAXIMUM level when filling the water tank. Put back the water tank.
2. Hold the appliance with your hand positioned safely at the neck of the garment steamer. In an upright position,
use your other hand to attach the fabric brush onto the steam head. the fabric brush can be attached either way
and will lock into position with an audible "click".
1. Water tank 280ml (removable)
2.Water tank release button
3. Steam button
4. Steam lock switch
5. Steam head
6. Fabric brush (removable)
7.power indicator light
8.Cord guard